Home

Injection Mold Temperature Control Systems
Improve your injection molding output....Switch to Tempco's MX Hot Runner Temperature Control System
The MX System includes:
Mainframes
2 types of Temperature Control Modules
Cables---Heater Power and Thermocouple
Wiring Junction Boxes
Input Connectors
Floor Stands
Accessories

Features
PID Control
CompuStep® Soft Start
CompuCycle®
Manual Control
Catalog Number:
TKA20001

Tempco's IMP Series Module provides one of the most technically advanced temperature controls available today. IMP modules use state-of-the-art microprocessor-based circuitry to perform all required PID functions. Units have built-in diagnostics and are fully self-tuning. Setpoint temperatures are maintained without the need to manually preset or adjust the control temperature. Merely set the desired temperature and turn the power on. The module will automatically sense the heat-up rate and control any setpoint temperature deviation.

Specifications

Temperature Range: Ambient to 999°F (535°C)
Sensor Input: Type J thermocouple
Control Accuracy: ±1.0°F (±0.5°C) dependent on total thermal system
Calibration Accuracy: Better than 0.2% of full scale
Voltage: 240 VAC standard, 120 VAC available
Power Output: 15A @ 240 or 120 VAC 50/60 Hz
Output Switch: Internal zero cross triac
Fusing: High speed fuses on both sides of line
Set Point Control: Precision 3-digit push button
Manual Power Control: Single turn potentiometer
Mode Control:
3 Positions: Top---Manual mode; Middle---Auto mode; Bottom---Auto mode with soft start

Features
CompuStep®
CompuCycle®
Easy Start-Up Procedure
High and Low Deviation Alarms
Open Thermocouple
Error Programming
Dual Digital Display
Advanced Diagnostics
Current Monitor
Catalog Number:
TKA20002

Tempco's AIM Temperature Control Module represents the state-of-the-art in Hot Runner temperature control technology. Virtually every feature a molder could want is contained in the module. The AIM's flexible microprocessor based flexible programming allows the user to modify 17 parameters via the front panel. Once entered, the non-volatile memory automatically saves the parameter modifications.

Specifications

Temperature Range: 32 to 999°F (0 to 535°C)
Sensor Input: Type J thermocouple
Control Accuracy: ±0.1°F (±0.1°C) dependent on total thermal system
Calibration Accuracy: Better than 0.2% of full scale
Voltage: 115 to 230 VAC, ±10%
Power Output: 15A @ 240 or 120 VAC 50/60 Hz
Output Switch: Internal zero cross triac
Fusing: High speed fuses on both sides of line
Set Point Control: two buttons---up and down
Manual Power Control: two buttons---up and down
Mode Control:
3 LEDs: Top/Manual mode
Middle---Auto mode
Bottom---Auto mode with soft start

Hot Runner Injection Mold Temperature Control Systems